About
The Letter

LAMiamiNY

Remodel

Who to Hire to Install a Range Hood and Makeup Air

How to size a range hood, duct it outside and plan makeup air above 400 CFM, and which trade handles each part of the job.

Range Hood Sizing and Makeup Air Checklist. Flexible aluminum duct attached to a metal range hood exhaust box, taped at the joint, sitting outdoors on paving stones.
Photo: Fumikas Sagisavas, CC0, via Wikimedia Commons

A powerful range hood is the one kitchen appliance that can pick a fight with the water heater. It throws the kitchen's air outdoors, the house wants that air back, and an appliance with a natural vent can end up supplying it through the flue. Three decisions keep the peace, and the code-minded sources behind this guide say to make them together, before anyone cuts a hole:

  1. Size the hood. Make it at least as wide as the cooktop, pick a CFM (cubic feet of air per minute) for the kind of range you cook on, and hang it 30 to 36 inches above the cooking surface.
  2. Size the duct and send it outside. Use duct wide enough for the airflow and end it at a cap outdoors.
  3. Plan makeup air. Above 400 CFM, the model code asks for replacement air roughly equal to what the hood exhausts.

The sections below take each step, then sort out who installs which part.

How to Size a Range Hood

For width, CopperSmith says an island hood should be at least as wide as the cooktop, and suggests 3 to 6 inches past each side for powerful gas cooktops. Its example is a 42 or 48 inch hood over a 36 inch gas cooking surface. The hood should also reach over every burner, especially the front ones, which are often the strongest on a gas range.

For airflow, CopperSmith's island starting points are 400 to 600 CFM for light electric, 600 to 900 for standard gas, and 900 to 1200 or more for professional gas ranges. Open-concept kitchens may need more capture area and CFM, plus proper makeup air.

Many hoods are now rated at 390 CFM maximum, just under the 400 CFM trigger for makeup air. JLC calls that enough for most ranges.

Range Hood Duct Size

The duct is where a good hood goes quiet and weak. CopperSmith says 6-inch ducting is likely inadequate for high-CFM hoods. Use at least 8-inch duct, and 10-inch for long runs or many elbows.

Ducting outside is also the safe default. A recirculating hood does not depressurize the house, so makeup air does not apply to it, but Jaspector notes such hoods are generally not acceptable in new construction under energy codes. The model building code has never required a hood itself, though state or local codes can require an exhaust fan, so check your own jurisdiction.

Makeup Air for Range Hoods

Jaspector says IRC 2024 section M1503.4 requires makeup air, approximately equal to the exhaust rate, when a kitchen hood exceeds 400 CFM. The rule dates to the 2009 IRC and was narrowed in 2018 to houses with naturally vented combustion equipment, so ask your building department which edition it enforces.

The risk shows up in remodels. With a hood at 600 CFM or more, equipment sensitive to pressure can start to backdraft, which means exhaust gases flow the wrong way. JLC reports that a new hood can do this to an existing naturally vented water heater, and that replacing it with a direct-vent model is a common fix.

There are two kinds of makeup air, and the code does not mandate either:

  • Passive: transfer grilles that let replacement air in. For 400 CFM, Jaspector says a grille typically needs "at least 2 to 3 square feet of free area", and passive may not keep up with hoods of 600 CFM and above in tight construction.
  • Active: a powered supply fan matched to the hood, which can be paired with a heater to temper cold incoming air.

Who Installs a Range Hood

No single trade owns a hood job, which is how parts of it get dropped between trades. Jaspector advises roughing in the makeup air ductwork, grilles and wiring at the same time as the hood duct, so the sequence matters as much as any one contractor.

  • Appliance installer: sets and connects the hood once the duct and power are in place.
  • HVAC contractor: duct sizing, the makeup air path and any tempering heater. If a water heater needs swapping to direct-vent, a plumber joins in.
  • Electrician: the hood circuit and, for an active system, the wiring that makes the makeup air fan start whenever the hood does.
  • Carpenter: framing for a chase or soffit, and solid support overhead for a hood hung 30 to 36 inches above the cooktop.
  • Roofer: if the duct leaves through the roof, the cap and flashing are theirs.

Questions to Ask the Contractor

Inspectors look at two moments. Per Jaspector, at rough-in they check that a makeup air pathway is planned for hoods over 400 CFM, and at final they check that it is installed and, for an active system, working together with the hood. Bring these questions to the first meeting:

  • What CFM is the hood, and is it over 400?
  • What duct size and route, and where does the cap sit?
  • Is makeup air required here, and is it passive or active?
  • Does the house have a naturally vented water heater or furnace that could backdraft?
  • Who roughs in the duct, grille and wiring, and in what order?
  • Who pulls the permit, and who is on site for the rough-in and final inspections?

At the final inspection, someone switches the hood on, and if the system is active, the makeup air fan starts up with it.

Highlights

What size range hood do I need?

Make it at least as wide as the cooktop, and CopperSmith suggests 3 to 6 inches more per side for powerful gas. For island cooking it starts at 400 to 600 CFM for light electric, 600 to 900 for standard gas, and 900 to 1200 or more for professional gas.

When do I need makeup air for a range hood?

Jaspector says IRC 2024 requires it, approximately equal to the exhaust rate, when a kitchen hood exceeds 400 CFM. Recirculating hoods do not trigger it, and local rules vary, so confirm with your building department.

What duct size should a high-CFM hood use?

CopperSmith says 6-inch duct is likely inadequate for high-CFM hoods. Use at least 8-inch, and 10-inch for long runs or many elbows.

More Stories

From LA Miami NY

A cabana daybed beside a rooftop infinity pool high above a curving bay, beaches and a city skyline
The Letter

Each new story from LA Miami NY, sent to your inbox when it is published. Nothing else. Leave any time.