Plumbing Renovation at the Open Wall
Before the drywall goes back, a repipe is the one job where a plumber can read a house like a page, and the trade is quietly rewriting it in PEX.
A typical 3-bath house hides 250 to 400 linear feet of supply pipe in its walls, and after demolition a plumber gets one clear look at all of it. The drywall is gone, the studs are bare, and every line that has been feeding the house for decades is out in the open. Once the painters arrive, nobody sees it again.
That look is why plumbers like to be called early. A major renovation is a natural time to judge the pipes, because exposed lines are easier and less disruptive to replace. In a gutted bathroom, a Bolster architect told Brick Underground, the branch piping, where most leaks start in older buildings, often has to come out anyway.
The first thing a careful plumber settles is what "repipe" means. It covers the supply lines. Drain, waste and vent pipes are a separate job. Quotes spell out the real scope, so "whole-home" shouldn't be read as every pipe unless the contract says so. That is the first question to ask, and the answer belongs in writing.
What Plumbers Find Behind the Walls
Most of what turns up in the wall is a matter of age. Galvanized steel was the residential standard from about 1900 to 1960, and it rusts from the inside out until the bore narrows. A house past 50 years old that has never been repiped may be due for that reason alone.
The other find plumbers dread is gray plastic pipe with brass crimp fittings in a house built roughly between 1978 and 1995. That is polybutylene, which breaks down under chlorine, and it counts as a reason to repipe whatever its condition. A plumber who spots it will not say wait and see. If the word Kitec comes up, the 2011 settlement was about a brand of brass fittings, not about PEX.
PEX or Copper, and Why the Trade Is Shifting
The bigger story is what goes in to replace it. PEX reached North America in the 1980s, and the trade has been leaning toward it since. It can run in one piece from a central manifold to each fixture, where copper needs a soldered joint at every turn. Fewer joints mean fewer and smaller holes in the drywall, and an easier patch afterward.
It also changes the calendar. One national repipe firm says its crews typically finish in a day and return later for patching, permits and inspections. AlertPlumber's comparison puts a 2-bath PEX job at 1 to 3 days against 3 to 5 for copper, and lists material at $0.50 to $2.00 a foot for PEX versus $3.00 to $6.00 for copper.
Copper still has its place. It comes in types M, L and K, thin-walled to thicker, and it can last 40 to 70 years with proper care. PEX degrades in sunlight, so exposed exterior runs stay copper, and joining the two takes dielectric unions. For a slab leak, the usual advice is overhead PEX through the attic or ceiling. If a bid names copper for an interior whole-house job with no stated reason, it is fair to ask about PEX-A.
The Fixtures They Rough In
Plumbers call the work inside the walls, before finishes go in, the rough-in. It sets the supply lines, the drains and the exact position of every fixture. This is where a design choice turns into a plumbing bill: "moving a toilet even a few feet can mean rerouting the drain stack", which Block Renovation puts at $1,000 to $3,000 or more.
The published numbers for the whole job run wide. A full repipe typically lands at $5,000 to $20,000 or more according to Block Renovation, and AlertPlumber puts 2026 whole-home work at $4,500 to $15,000 for a 2 to 4 bath home, with PEX 30 to 50 percent cheaper than copper. Smaller fixes sit lower: $250 to $900 for a spot repair, $1,800 to $4,500 for a partial repipe. Those are ranges from firms that sell the work. A walk-through with the walls open is what turns one into a number for your house.
Risers in Old New York Buildings
In an old New York building, the pipe that matters most may not be in your unit. Galvanized risers collect scale and rust until upper floors get a trickle. NY Engineers recommends building new risers alongside the old ones and then switching over, because old systems may lack isolation valves and brittle pipe can snap. They advise against partial upgrades, since new and old pipe in contact corrodes faster. Sanitary Plumbing says its first question is whether the chase has room for new pipe beside the old, and it fixes mains and risers before in-unit branch lines.
The questions for a co-op or condo follow from that. Management generally handles the service entrance and risers, while the shareholder generally pays for branch lines, and most buildings do not let risers be moved. NYC law allows only a Licensed Master Plumber to carry out major plumbing projects, so ask to see the license. Opening walls for riser work may disturb asbestos or lead-based paint, and a plumber will want to know whether a backflow device is present.
Then the crew goes into the chase, and the new riser climbs beside the old one. For a while both stand there, one still carrying water, the other waiting for the switch.
Highlights
What is a whole-home repipe?
It means replacing every supply line, not the drain, waste and vent lines. The contract should document the actual scope.
How much does a repipe cost?
Published ranges run $4,500 to $15,000 from AlertPlumber and $5,000 to $20,000 or more from Block Renovation. AlertPlumber says PEX is 30 to 50 percent cheaper than copper.
Which old pipes usually need replacing?
Galvanized steel, standard from about 1900 to 1960, rusts from the inside out. Gray polybutylene in homes built roughly 1978 to 1995 is a repipe trigger regardless of condition.
Sources
- Copper vs. PEX: Choosing the Right Material for Repiping | Intelligent Design Tucson
- Whole-Home Repipe: The Complete Guide
- PEX vs Copper Plumbing | AlertPlumber
- How Much Does It Cost To Repipe With PEX?
- When Should Plumbing Risers be Replaced?
- Plumbing Issues in Condos and Co-ops: Unique Challenges in Repairs and Upgrades - Sanitary Plumbing
- What NYC homeowners need to know about updating their plumbing
- Plumbing Installation Costs - All Questions Answered
